(Pre-1999 variation, using order 11 polynomial)
This projection is a variation of the Transverse Mercator projection used in Denmark, and is also referred to as UTS34. The projection consists of a base UTM (zones 32 & 33) calculation, which is then adjusted by an order 11 polynomial.
The polynomials used in the Danish System 34 projection were developed by K. Poder and K. Engsager of Kort & Matrikelstyrelsen. The polynomial coefficients can be obtained by contacting Kort & Matrikelstyrelsen.
Note that this projection was superceded in 1999, by a newer version that uses an order 13 polynomial to further adjust the results achieved using this projection.
The "Danish System 34" projection has the following parameter:
-
Region
Region is used to indicate which part of Denmark the projection is being applied to. The valid region values are as follows:
|
Region |
Key |
|
Jylland |
“j”, “J”, or “1” |
|
Sjælland |
“s”, “S”, or “2” |
|
Bornholm |
“b”, “B”, or “3” |
|
National |
“u”, “U”, or “4” |